Log into Facebook
Log into Facebook to start sharing and connecting with your friends, family, and people you know.
www.facebook.com
Details
- Condition
Used - like new
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
www.facebook.com
Bit late now...Dang, I should have asked if you have any brass feeler gauges. I have never owned one.
Get it running?
I didn't get a chance to get over to it yesterday. I'' get over there today. Hey, the start and ign power wires are supposed to be connected when you do a conversion. Right? I think I'll take the book over in case I need to do some electrical tests.
NOTE: actually not. The engine crank wire feeds the coil opposite the run (power) side of the ballast.
Last edited:
Morning, been up cleaning windows before the sun comes up. After the house bug treatment yesterday they were a mess............................
Last edited:
Good morning.
Nice spring day here, 19*F with a fresh layer of snow on the ground.
Nice spring day here, 19*F with a fresh layer of snow on the ground.
Single ballast yes
That elect. ign. manual is great!
Sorry Fred, at least enjoy your cup of coffee...................Good morning.
Nice spring day here, 19*F with a fresh layer of snow on the ground.
Good morning guys. Not to rub it in Fred but it’s going to be 80 here and sunny. I have a funeral to go to today. My mother in laws best friend passed. I’m just going for moral support and to enjoy the ride down along the river.
Weather should be good today to do the spring cleanup and weed spraying.
Sorry she lost a close friend Steph.
Get er' done!! I have some sticks to pick up and a few old flowers to cut back. Oh, never ending battle cutting out volunteer trees. I have a lot of those at the other house along the fence. I have some vegetation killer you paint on the stump that kills the roots. Mostly mulberry trees.
Will do!!
Sorry for her loss. It's good you can be there for her.
This one sounds like a mess. What did I do wrong here (HEI Conversion)
Hey Ray when you get a chance look up
tyco electronics cold casting material # rpn:75993-002
I have 100 tubes of it and the applicator gun and a few mixing tips.
If you can use some I'll send it to ya.
Could that be potting material for the ECU's ?
Morning!
-8, +2 for a high. Maybe some sun later. Looks like the snow will be hanging around for a while. Want to get the brake stuff wrapped up today, pull pedal and make a new pin to connect to booster.
-8, +2 for a high. Maybe some sun later. Looks like the snow will be hanging around for a while. Want to get the brake stuff wrapped up today, pull pedal and make a new pin to connect to booster.
What's potting material?
It's made to cover computer chips for protection, I think.
Yep, it's the stuff on the back of the ECU's that covers up the circuit boards.
Yes I think so. I hate to throw it all away but I have no use for it.
Saturday! Where did the week go, so sorry for your loss, glad you are able to go give the family members support as they go threw this day @Petty Betty
-
Similar threads
