Stop in for a cup of coffee

-
K.. so.. i will need to remove and replace my tower bushing in my block... getting it out should be nothing.. can the new one be driven in using a old oil drive shaft? i know they make a special tool.. but....
 
K.. so.. i will need to remove and replace my tower bushing in my block... getting it out should be nothing.. can the new one be driven in using a old oil drive shaft? i know they make a special tool.. but....
Distributor bushing? I've never replaced one. There is a burnishing tool to size it properly .
 
Dang, coffee is done and I'm just sitting here staring at the screen! :BangHead: :BangHead: :rofl:
Here is a screen shot for ya Mike.
1745065598357.png
 
I got my seat track extensions. It will be nice to add an extra 2" (que Karl) to the adjustment.

20250419_072231.jpg
 
AHH... so you can use a old dist drive to get the bushing install then tape one of these through to size the bushing... costs like $10
1745066196204.jpeg
 
I am in the lazee boy on the porch buried under a quilt seventy pound pup on my lap watching and listening to it pour down rain. The thunder and lightning is intense. I am guessing only a couple inches so far, nothing like that last one. Morning all! Safe travels Mitch.
That sounds like fun.
 
It just dawned on me the other day that the speedway is having Go Kart Sunday on Easter :wtf: I know racers have priorities when it comes to holidays and racing, but I think Easter Sunday might be a real attendance cutter for the track. :realcrazy:
 

-
Back
Top Bottom