Stop in for a cup of coffee

-
Morning . Toronto looked like a junior team last night against the Panthers, to many penalties and your not going to win a game if the shots are 24 to 37 .
That shots on goal was pretty glaring. Maybe more "cheap shots" on players than I've seen lately in playoffs too
 
Morn'in Gents. Busy weekend. Worked on my wifes 2004 BMX X3 so we can drive safely to NC. in a few weeks. Did a front brake job. Then both rear drive shafts and wheel bearings and new hubs. Nothing easy there. On the floor from 4pm to 11pm Friday night. Then 9:30 AM - 4pm Saturday. Then push mowed the 6" grass Sunday morning before more rain coming as I'm waiting on a coil for the Ride on mower. Just glad it's all done. Whew!
 
Morn'in Gents. Busy weekend. Worked on my wifes 2004 BMX X3 so we can drive safely to NC. in a few weeks. Did a front brake job. Then both rear drive shafts and wheel bearings and new hubs. Nothing easy there. On the floor from 4pm to 11pm Friday night. Then 9:30 AM - 4pm Saturday. Then push mowed the 6" grass Sunday morning before more rain coming as I'm waiting on a coil for the Ride on mower. Just glad it's all done. Whew!
I don't know what working on a BMW would be like but I did have a Saab 900 once, think it must be something like that : ) Push mower, yikes! I need to change a spindle on my rider before it blows apart
 
My Dad had a set of Glen L plans for
1747055485250.png

Probably to be a home for that Edelbrock assisted Flathead he had under the work bench after he retired from El Mirage Dry Lake.
Not much room in there for the family though.
Them Cracker Boxes do have their uses though :steering: :D
1747055758451.png
 

Been working through some of the "hits" on our home inspection in prep to sell. The heat pump was pretty unlevel, must have settled. Started on the garden which is a jungle of Canadian Thistle and stinging nettle- mow first, weed eater on fence, roto-till, not looking forward to it lol!

h1.jpeg


h2.jpeg


h3.jpeg
 
3 divisions of open wheel racers at the Speedway this Saturday night. Sprint Cars and 2 of the vertically challenged divisions :lol:, Midgets and Dwarf Cars. Factory Stocks also for track compaction :rolleyes::lol:
 
3 divisions of open wheel racers at the Speedway this Saturday night. Sprint Cars and 2 of the vertically challenged divisions :lol:, Midgets and Dwarf Cars. Factory Stocks also for track compaction :rolleyes::lol:
I like the 410's, haven't been to Skagit Speedway in a while, should go as always a good time
 
I don't know what working on a BMW would be like but I did have a Saab 900 once, think it must be something like that : ) Push mower, yikes! I need to change a spindle on my rider before it blows apart
Front brakes were a breeze but accessing the axle shaft assemblies for removal sucked. Had to lower exhaust, remove spare tire and spare tire holder, and remove rear sway bar.
Still wouldn't have been too bad but rusted bolts one which I snapped on sway bay mount which I drilled out and re-tapped and replace bolt. Pulling hub wasn't bad but pressing out and in new bearings were a challenge as I made my press tool rather than buy it for $275.
 
-
Back
Top Bottom