500… 512… 528… 543… which do you chose
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
OK dukey is blocked! 
??????????????????????????????? WTF dude. Are you on pain meds or something this morning?
See....I learned a long time ago not to try to out do Hoppy. He has this sick deviate mind that you just have to love (and worry about). I love the guy....but not his ways alwaysOK dukey is blocked!
OK dukey is blocked!
I know a couple guys that can make that happen.
Maybe we should all block Dukey??????????????????????????????? WTF dude. Are you on pain meds or something this morning?
We could. He might get his house built faster. Or, get his Dart done. Naw, that won't happen!
You all were being too quiet… had to do something to break the ice??????????????????????????????? WTF dude. Are you on pain meds or something this morning?
And yes, gabepiten??????????????????????????????? WTF dude. Are you on pain meds or something this morning?
Can’t control weather… too windy to handle 26 ft long sheets.We could. He might get his house built faster. Or, get his Dart done. Naw, that won't happen!
Stroker Kits-store.440source.com??????????????????????????????? WTF dude. Are you on pain meds or something this morning?
It is coming along nicely. You get it sealed up and then you can run a generator and a Torpedo heater and get some wiring done. Then plumbing and Hvac.
For your Dart? A stock stroke 440 will be a handful in that car. Bigger is just more dangerous and not fun to drive.
6 - 7
Just day dreaming… I dropped off my spare 440 block to have prepped since the cylinder wall of my original one has cracked and busted a chunk off
Stroker Ace Sizes......???????????????????????????????? WTF dude. Are you on pain meds or something this morning?
Yep
Well since the Dart was brought up. Decided I needed to take an inventory of what needs to be finished by June.
Primer, block sand and Paint(optional)
Brake Plumbing
Custom Driveshaft
Radiator-cooling system
Engine and Trans put back in the thing.
Prime with fluids
Plumb fuel system
Wiring harness install
Carpet and underlay install
Seat and belt install
Dash install (complete, just waiting on the installation)
HVAC (optional but I'll probably want it for the Tour)
Nice part is.... I have all the parts minus the engine block, which should be back by end of January. Can I pull this off... unlikely but i'll try.
Primer, block sand and Paint(optional)
Brake Plumbing
Custom Driveshaft
Radiator-cooling system
Engine and Trans put back in the thing.
Prime with fluids
Plumb fuel system
Wiring harness install
Carpet and underlay install
Seat and belt install
Dash install (complete, just waiting on the installation)
HVAC (optional but I'll probably want it for the Tour)
Nice part is.... I have all the parts minus the engine block, which should be back by end of January. Can I pull this off... unlikely but i'll try.
Unconventional
Well-Known Member
4 hrs 20 min O'side to home including gas stop to save almost $1/gallon. Not too bad. My AM traffic report go-to was too busy talkin' investments this morn or I would have taken another route, but it didn't work out too bad. Nice an sunny here for now. Ugly and wet gets here Tuesday and stays for the rest of the week
Could be worse Alex, I have a 2 foot drift of snow in my front yard. Not complaining just a normal day here.
-
Similar threads
