roylerumble
Well-Known Member
So I'm having issues with fittings and hoses matching up my federal PS pump to the rack and pinion on my RMS AlterKtion, so I found a saginaw and brackets and I'm attempting to do the swap. Having issues on alignment, I'd say the pulley on the pump is about 3/16" too far back. What is an acceptable tolerance? Should I stuff a couple spacers between the block and mounts to shim it out?
Thanks fellas, this is the last issue before I get to fire up and drive the beast.
Thanks fellas, this is the last issue before I get to fire up and drive the beast.