What is this tool thread? Take a guess. Stump the Toolman!

[Bodyperson]

sheet metal nibbler

It for bending back and re-crimping the plastic tank retaining tabs on aluminum radiators.

 

[toolmanmike]

Try this one.

View attachment 1716011895

Neat thing about this one is that it doesn't distort like shears do.

 

[Bodyperson]

View attachment 1716011989 Neat thing about this one is that it doesn't distort like shears do.

That’s not what it is but it sure looks like one.

 

[toolmanmike]

That’s not what it is but it sure looks like one.

Same handles anyway. It's possible a different jaw was added for crimping radiators. It looks like it has that strange hook jaw.

 

[Bodyperson]

Same handles anyway. It's possible a different jaw was added for crimping radiators. It looks like it has that strange hook jaw.

View attachment 1716012006

Notice the depth adjuster for the crimp. Just an offset square.

 

[pishta]

Hand Drill

Wonder where I can get Phillips and standard screw bits for it.

 

[bcschief]

Wonder where I can get Phillips and standard screw bits for it.

Only made to drill

 

[Bodyperson]

Wonder where I can get Phillips and standard screw bits for it.

Are the drill bits in the handle?

 

[Dfr360cuda]

View attachment 1716011989 Neat thing about this one is that it doesn't distort like shears do.

Nibbler ?

 

[bcschief]

Are the drill bits in the handle?

You loosen up the knob about mid way down the body and slide down the handle to expose the drill bits, they are a special bit with a flat ground on one side.

 

[bcschief]

That’s a yankee screw driver

No it's a Yankee hand drill.

 

[bcschief]

And if found in Florida it's a damn Yankee hand drill.

 

[pishta]

Nope, no bits in the handle.

 

[Bodyperson]

Nope, no bits in the handle.

Bummer. I have a drill and a screw driver around here somewhere. Basically the only difference is the driver is reversible. Cool tools

 

[halifaxhops]

 

[halifaxhops]

 

[FISHYPETE]

Cut it off

 

[halifaxhops]

Cut it off

For what Pete?

 

[FISHYPETE]

Exhaust?

 

[halifaxhops]

Winner!

 

[halifaxhops]

The other one will be a hard one. I was stumped actually on it.

 

[Jadaharabi]

The other one will be a hard one. I was stumped actually on it.

The other one is a valve keeper holder for when you're assembling your cylinder heads.

 

[Max1196]

340. have that tool. 347 , correct. Used for a "side load" situation.

 

[halifaxhops]

The other one is a valve keeper holder for when you're assembling your cylinder heads.

Yes

 

[Tooljunkie]

Yup. It might be in my drawer of tools I hope I never need again. Lol. Might need a bigger drawer for those tools.

I had a reputation for fixing those types of columns,did them all the time. Not many guys around here would touch them. And its better to have it and not need it than need it and not have it.