Stop in for a cup of coffee

-
That sounds like a plan. Unfortunately I have to go get the wifes prescriptions and see all the local Darwin Award winners in the area.
 
Raining pretty hard now, fire is on in the shop, tunes are on!
Sort more hardware and work on a plan to pull the cab off my fargo. Think i will install some brackets to the ceiling and use a 4x4 through the cab windows.
 
PO called me up to many boxes. This is one of them.
s-l1600.jpg
s-l1600.jpg
 
I like it because of not only the inductive tach pick up but also amps. Definitely some deals out there with everyone home and I guess cleaning out stuff.
 
Sorting hardware. Should just chuck it. But theres lots of good stuff. Going bugeyed though.
 
dukeboy_318 said:
Haven’t totally nailed it down yet. I did Tims hot wire that got it to run and I got it to idle down a bit, still a bit high. I’ll have to figure out where the short is at some point in the harness.

But we were talking and I got looking, the passenger side exhaust flapper is rusted closed. So that may be part of my issue. So I’m cutting that out today.
Click to expand...
NOT A SHORT!!! If there was a short it would let you know with fire and melted wires. An OPEN!!!
 
Last edited:
How come whenever someone has a problem with wiring, it is always a SHORT? :BangHead::BangHead: Jeeezzzz
 
zkx14 said:
Cause it’s never too long? :rolleyes:
Click to expand...
Maybe....Smoke would be the give away if there were a short. I am going to send Chris my old Navy manuals from when I was an instructor BE&E school in the navy. Good basic stuff....
Just have to dig them out...
 
Mopar Tim said:
Maybe....Smoke would be the give away if there were a short. I am going to send Chris my old Navy manuals from when I was an instructor BE&E school in the navy. Good basic stuff....
Just have to dig them out...
Click to expand...
Hey when you got to Carlisle plan an extra HOUR and stop by and fix this for him.
We'll kick in any extra gas money required.
:rofl:
 
Mopar Tim said:
Maybe....Smoke would be the give away if there were a short. I am going to send Chris my old Navy manuals from when I was an instructor BE&E school in the navy. Good basic stuff....
Just have to dig them out...
Click to expand...
He can use them like I did with my college books. I had to change a flywheel with stripped teeth for starter on sisters AMC Spirit. I used the books as supports under engine and trans. :lol:
 
Wife is suppose to start working from home Monday. Well she decided to start today...what I need advance warning.
So after the Sam's and grocery store run I had to drag a large folding table upstairs to the office. She claimed the office desk isn't big enough for what she needs. I help her clean it up and set up her stuff. I put away all the groceries and take the GD to her Dad's.
I come back settle in my chair to finish my coffee and watch a little TV. I hear from the office "I can hear the TV". I reply "ok what do you want to listen to...hey shut the door".
Might take a day or two to get use to. Its only a month...I hope!!
 
ZMan67S said:
Wife is suppose to start working from home Monday. Well she decided to start today...what I need advance warning.
So after the Sam's and grocery store run I had to drag a large folding table upstairs to the office. She claimed the office desk isn't big enough for what she needs. I help her clean it up and set up her stuff. I put away all the groceries and take the GD to her Dad's.
I come back settle in my chair to finish my coffee and watch a little TV. I hear from the office "I can hear the TV". I reply "ok what do you want to listen to...hey shut the door".
Might take a day or two to get use to. Its only a month...I hope!!
Click to expand...
Going thru this with Simone. It will not last, I hope...
 
You must log in or register to reply here.
-

Back
Top