Recent content by 64dartwagon

btt

There's another one on the car I'm selling, and it's connected to a roof and the other side.:)

Bump. I'm pulling parts out of the shed today and will post more pictures on this site: http://s1036.photobucket.com/albums/a442/64dartwagon/For%20Sale/ Car and all parts related for $2500 obo.

Quarter panels are gone. Thanks AARON! Also selling new Hooker Super Comp Headers #5208 that I picked up years ago they were put in and taken back out painted white except for part of one tube that was bead blasted. $350 O.B.O. pickup only 9" Ferd Moser housing round back with 31 spline...

bumpity bump

Some Pics http://s1036.photobucket.com/albums/a442/64dartwagon/For%20Sale/

Putting up for sale what used to be my 1964 Dart Wagon. V8,78 Volare 318, 904auto, 8 1/4 rear all from donor vehicle. Has Hooker Super Comp Headers, DynoMax 18" bullet mufflers. 16 gallon fuel cell, holley blue pump, all fuel line is -6 with AN fittings. Carb is a Edelbrock along with a...

Do you have the window plate for the bottom of the glass? Some glass shops have the measurements for it as it's flatglass that's tempered. I'll check to see if I still have a window crank with key available.

http://sfbay.craigslist.org/nby/cto/1780727551.html

Well that sucks. I've been lucky with the few that I have come across. Another thing to try them is a large easy out. Preferably the square shank kind. http://www.bassesbyleo.com/images/l2k_jack/easy_out.jpg

It's a square drive in the hole. Use a 3/8 extension in the hole.

In need of a serious ground. Motor to frame, pump to body/frame, ignition box to clean ground also. Ground lead is often the cause of many gremlins.

Yes I've had those before, and they were a week long sometimes. Good time to go out and destroy somthin!

They get to be kinda addicting. I myself have been into them before cars. Everyone in the house shoots, all the way down to the 4yr old. I have looked into getting a XD40. Down here in the Peoples Republic of Komifornia it has to be on a roster of "California Approved", unless you are Law...

Your car is po'd for putting GM parts in it. And it's letting you know. Check to see if rotor is centered in the pads, greased the caliper pins?? Spray anti squeel might not be enough. Semi metallic pads or organics?