Recent content by 70dusterjohn

Slicks

Thanks guys for all the help, I did wire it for the new system, I've done the same on 68 Coronet R/T , 68 Coronet, 67 Baracuda, and 69 Dart, all work great, well except for my 67 Coronet, and it worked fine for 2 years, then all of a sudden this happens ! I'm stuck!!!!! I have so many schematics...

Checked the bulk head, checked all charging system wires and then some! I can't find the problem! What to do, what to do??????????Sell it???? It really sucks, its nice out and would really like to drive it! :wack:

Did all that and then some, still the samething???? I don't know where to go with it!!!!!!

Ok, what I have is on my street car, went to the new style charging system about two years ago! Now the car will not charge at all , with either system???? The car is a 67 dodge with a 440. Any help would be great! Anymore I go out to work on and end up just staring at all those f@#king wires...

Well phil that little Duster was flying on that last pass!!!! Just thought I'd say hey, dad said hey, and you have one h### of a nice car! Hope to see you out at 42 again soon!

I ran a 440 with 12.5 -1 trw pistons, stock rod or go with aftermarket h-beam rods, stock forged steel crank, mp 312-590 cam and a set of unported 915 heads! The car ran a best of 11.36, I then upgraded the heads to 63 max wedge heads off a 413, added nothing else and ran a best of 10.89! That...

:thumblef:

comp. enginering!!!! Good over all fit!

I know what you mean!! Check with a napa or advance auto arouns you, my advance store carries them in stock!!

I've reused them in the past, but would spring for a new one if you can! If you do use it make sure to use a small amount of sealer around the port areas! I've never had any problems reusing them, but use the sealer just in case! Hope this helps! :thumblef:

Rumblefish I belive, he's running a big block, You are right for the small block though! Both ports at the back of the big block are pressure ports!

:thumblef:

Yes, either one will work!

Yeah thats what I thought Lancester!! Put a 340 in a Barracuda for my father, was a 318 car, all I need to do was find another passanger side mount from a 318 and use that for the drivers side, worked great , and was cheap!!