I have decided to install a Speedway straight axle kit to my 73 Dart.
The Darts front end was/is completely disassembled when I bought it and I don't have an easy way to determine the front hub to hub measurements.
Does anyone have these measurements? I need to know before I order the kit what...
My daughter and I pulled everything out of a full sized PU w/6. the aluminium 4 spd (3 speed w/od) has been in for 8 years. I had to re-clock the Z-bar but everything fit in her 73 Dart. A body peddle assemblies are easy enough to convert. With a new clutch kit we had less than $200 in it. She...
When the gauge quit on the Super Bee during the 05 Hot Rod Power tour, we went to radio shack and bought a cheap multimeter. unhooked the gas tank sending units wire by the drivers kick panel connector going to the dash. grabbed ground and ran the two wires between the bucket seats. My daughter...
An awful lot of people obviously like him. But in the end it's just a show!
Right up there with Duck Dynasty. It's like the Dukes of Hazard jumped over 15 cars and you saw the cowl buckle when the thing hit the ground. But the next shot their swerving on down the road.Sooner or later ***...
Try from FBBO
http://www.forbbodiesonly.com/moparforum/showthread.php?57128-Instrument-Voltage-regulator-or-limiter&highlight=voltage+regulator+for+dash+gauges
Yes they aren't the greatest things to look at but they work very well. I have at least 4 of them on different vehicles and haven't had any fail. One is in my chopped 66 Chevy 1/2 ton w/440 and it's been there since 2000. They just work.
X2 I found mine at a Good will store. I put added a vacuum gauge from an old ac gauge set along with 2, 1/4" male fittings. One to hook up a vacuum/evac. pump. The other one has a tube running inside to about 1/4" from the bottom inside to pull down/out fluids.I use it all the time. That sucker...