Search results for query: *

I have two pairs of visors. The black ones are uncovered and have been modified by the previous owner of my car. He glued a thin hard plastic over the original cardboard. They are out of my 1964 Dart. The blue ones may be for a later model Mopar? They are a bit larger than the early A visors...

I have an unused set of front door seals for 1962-1966 A & B Body 4 door sedans. I am guessing they would fit the front doors of a wagon as well since it is a 4 door. They are black in color. They were ordered from RockAuto and are made by metro. These are currently $118.99 at Rockauto.com. I...

Doing a general tune up, oil change, and tire rotate on my car this evening. 170 slant six with a Carter BBS. Checked the timing and when I disconnected the vacuum advance from the carb, I noticed the tube fitting felt loose. With a small amount of gentle persuasion I was able to pull it out...

For sale is a brand new set of 1963 through 1966 Dart four-door sedan and wagon top cat whiskers. These are the felt pieces that snap to the inside and outside of the doors and seal off the window glass. I pierced a hole in the bag to remove one and inspect it. I paid 89.99+ shipping for these...

Getting ready to mount my driver and passenger outside mirrors. I have no templates and the car doesn't currently have either mirror. I tried holding the mirror foward of the 1/4 window and it works. I have held it parallel to the chrome 1/4 window rear vertical post and it too works. Both...

Hello all, Would anyone please help me to decode my fender tag and build sheet? I have the three books from Galen Govier, but I have no clue where the gremlins hid them in the garage. Seriously, I pulled open boxes that haven’t been touched in forever trying to find those books and they are...

I just got home and when I shut off my 64 Dart I noticed the ignition switch felt warm to the touch. The heat was not on in the car and the switch in the 64 is not part of the column. So it’s not engine heat. I got up under the dash and the wires that plug into the back of the switch are really...

My question of the day is about the Holley one barrel glass float bowl. I found one for sale and the current owner states it is for a Holley 1904. I am trying to figure out if it will bolt up to the Holley 1920? The shape and size look identical to me, but I can’t find a parts list that show...

So I just bought my first ever NOS carburetor. It is over 50 years old and still in its original box with tags and directions etc. can’t wait to get it on the car. Anyway, I want opinions. Should I disassemble this unit and replace all the gaskets and the needle and seat? Or should I just throw...

I found a set of 14 inch small bolt pattern aluminum slots for sale. I don't know if they will fit on the front of my car, so I am here to ask the experts before I buy. According to the owner they are: Fronts 14x6 with 235/60/14 BF Goodrich Radial T/A's Rear 14x7 with 235/6014 BF Goodrich...

I have a 1964 Dart with a 170 slant 6 and A904 auto. The car currently has a Holley 1920 that has been rebuilt at least one time before I rebuilt it. I can’t get a good idle below 800-900 rpms. I can’t even screw the idle screw down lower as it is not currently touching anything. I believe there...

So I have a 1964 Dodge Dart with /6 and A904 push button auto. Trans came out the car for a rebuild and I have been tearing down and cleaning the sub-assemblies for the rebuild. Trans ID is 2408002S which is a 1963 A904 HD and the production date or serial stamp is 0891693. When I got the...

So my 64 Dart 4 door has Anchor brand front seat belts and only one Anchor brand rear seat belt. As I see it, the front seat belts are in the correct factory installed holes in the floor and maybe replaced the factory originals. I will be installing my new front seat belts in the same mounting...

Just brought home my new daily driver. 1964 Dart 170 4 door. Its equipped with the 170 /6 and push button auto trans. I pulled the intake and exhaust manifolds to fix an a exhaust leak. I noticed the rotating wheel and spring are not on the exhaust manifold. After I have the manifolds off...

Hey all. Just brought home my new (soon to be) daily driver. The previous owner salvaged the speedometer cable to use on his sons car, so my car has none. Anyone have a 1964 Dodge Dart speedo cable laying around that they want to sell? I also need the bolt and bracket that hold it into the...

I am new to the forum, so thank you for the assistance! I am looking at a 64 Dart 170 to buy as a semi-daily driver. The car is great, the engine is great. The question I have is about the intake to exhaust manifold gasket. When looking at the connection point of the intake/exhaust from the...