Awesome. I'll get to drawing it up in the next few days.
Your choice for the "1" with or without a lower bar.
Your choice for the "1" with or without a lower bar.
318 custom badging?
- Thread starter j_anderson
- Start date
-
With the foot would be my choice. How hard would it be to draft it each way?
Probably have to shrink the whole thing down a little to make it fit the double hood scoops
No problem
Take a photo of the emblem and scale it to a size you like and try it on the scoop. Once you find the right size get me the dimension
I REALLY LOVE THIS!!! Even better if there was a "right" and "left" version (one slanted right - like these , one slanted left, so they would both be slanted forward on the scoop. Where did these come from????
Agreed but I ordered a pair of them to mess with
@Dana67Dart has been hard at work creating what we need to take these emblems to the next step.
I mocked up one of his prints this weekend.
Excited for him to put the finishing touches on the drawings! Huge thanks to him for doing this!
I mocked up one of his prints this weekend.
Excited for him to put the finishing touches on the drawings! Huge thanks to him for doing this!
Last edited:
I like that one too but I don’t think there is enough room on this scoop for that long emblem at least oriented the same way.
We used the factory 340 pin holes to locate this one in the same space. To mount the longer one on the scoop, it would run uphill in the back? Like the 340 call-out, the emblem above sits parallel to the ground.
Last edited:
That would be perfect to have the pins the same as the 340 emblem. I could use a couple myself.
Update. I sent @Dana67Dart 's emblem file to an online vendor to have printed in 316L steel. I chose the polished option but you could still see the print layers. I spent some time sanding the surface with some 1200 grit paper until the print layers were leveled out. I painted the emblem then wiped off the surface while the paint was still wet leaving the sides in black. Turned out pretty good!
That looks perfect!
He did a bang up job on the drawing! I’m going to final sand the surface tomorrow then shoot it in clear coat.
On the left is how it looked when I got it. On the right is smoothed and painted.
Last edited:
$30 a piece
for sure. these are smaller though too. the numbers are the same size as the 340 hood scoop callouts. but yea, $60 and a little sanding/paintwork for a pair isn't bad.
Any chance you could arrange a bulk buy if folks paid up front?
I guess we could see what the interest is and go from there!
Update to the 318 saga!
I now have cad for:
318 FOUR BARREL (273 FOUR BARREL font, sized and pined for the 340 hood scoop location)
318 (340 font, sized and pined for the 340 hood scoop location)
318 FOUR BARREL (273 / 383 FOUR BARREL font, sized and pined for the 67 (up?) Dart 273 FOUR BARREL fender location)
And the newest addition
360 (340 font, sized and pined for the 340 hood scoop location)
I now have cad for:
318 FOUR BARREL (273 FOUR BARREL font, sized and pined for the 340 hood scoop location)
318 (340 font, sized and pined for the 340 hood scoop location)
318 FOUR BARREL (273 / 383 FOUR BARREL font, sized and pined for the 67 (up?) Dart 273 FOUR BARREL fender location)
And the newest addition
360 (340 font, sized and pined for the 340 hood scoop location)
-
Similar threads
