Whatsup1962
Well-Known Member
Winter project hit its final stages on the dyno this month.
Was looking for a good street build to drop in the Demon that I could throw some spray on.
Sourcing parts over the Winter was not easy. I ended up sacrificing some on the camshaft and possibly some on the intake....nothing was available. My goal was 500/500 and exceeded and feel short at the same time. Motor seemed to like 35 degrees of total timing the best. Here is the info on the build and results.
Scat forged stroker kit - compression came out to 10.38 to 1
Trickflow out of the box heads.
Comp Cams Hyd Roller XR286HR - Dur@.050 236/242 Adv 286/294 - LSA 110 - lift .544/.541
Harland Sharpe 1.6 RRs
Air Gap knock-off port matched to heads.
Holley 750 dp with 1" spacer.
Should make the Demon....well a Demon.
View attachment 1715935630
Was looking for a good street build to drop in the Demon that I could throw some spray on.
Sourcing parts over the Winter was not easy. I ended up sacrificing some on the camshaft and possibly some on the intake....nothing was available. My goal was 500/500 and exceeded and feel short at the same time. Motor seemed to like 35 degrees of total timing the best. Here is the info on the build and results.
Scat forged stroker kit - compression came out to 10.38 to 1
Trickflow out of the box heads.
Comp Cams Hyd Roller XR286HR - Dur@.050 236/242 Adv 286/294 - LSA 110 - lift .544/.541
Harland Sharpe 1.6 RRs
Air Gap knock-off port matched to heads.
Holley 750 dp with 1" spacer.
Should make the Demon....well a Demon.
View attachment 1715935630
Last edited: