auto trans

[Raymond Kitchen]

what trans. auto was in in65 barracuda with 273 engine

 

[67Dart273]

Only one possibility. Torqueflite A904

 

[Raymond Kitchen]

Only one possibility. Torqueflite A904

 

[Raymond Kitchen]

Thanks

 

[chewy]

If you are using the original driveline you will want one with the Ball and Trunion output shaft (64-65 only).

 

[Locomotion]

.....with a small converter snout and different splines that don't interchange with the more common later versions

 

[Professor Fate]

...and cable shift, and small speedo adapter...

 

[bcschief]

Also last year for the rear pump which takes a different transmission filter, which means it can be push started unlike 66 and newer

 

[AJ/FormS]

That'a a pretty good trans. I put a 340 2bbl in front of one and ran the snot out of it for a couple of years.

 

[Charrlie_S]

64 and 65 are the only 2 years for the cable shifted small block 904. However there are differences. The only difference that matters as far as fitment is the valve body. 64 and 65 have different valve bodies, as the 64 was push button shifted, and 65 was either column shifted or floor shifted. The valve bodies can be swapped. There are some other differences that matter if rebuilding.

 

[cudamark]

If you are using the original driveline you will want one with the Ball and Trunion output shaft (64-65 only).

Actually, the interchange is much greater than that. Even some B-bodies used the same one. It's a matter of length, coupler, and U-joint size.