Wally 1966
Kare-Bear1966
Recently purchased a 70s 904 transmission to rebuild for my car. Upon opening I have found that it has a Cheetah #17156 reverse manual valve body.
As I am completely unfamiliar and this is my first “trans build“ I obviously have some ‘stupid’ questions.
I have looked extensively on the inter-web but can find no diagrams showing how this valve body should be put together to verify that it is in fact put together correctly. Upon opening there was a single steel ball that unfortunately stuck to the separator plate and rolled off so I have no idea for sure where it goes.
Is it possible to convert this valve body to a standard valve body and install a TCI trans kit? Or would it be better to market this unit and purchase/trade for a stock valve body?
I have looked a crossed our threads but can’t seem to find anything that points directly to this valve body or how it is constructed/set up so any links to threads would be greatly appreciated as well.
As I am completely unfamiliar and this is my first “trans build“ I obviously have some ‘stupid’ questions.
I have looked extensively on the inter-web but can find no diagrams showing how this valve body should be put together to verify that it is in fact put together correctly. Upon opening there was a single steel ball that unfortunately stuck to the separator plate and rolled off so I have no idea for sure where it goes.
Is it possible to convert this valve body to a standard valve body and install a TCI trans kit? Or would it be better to market this unit and purchase/trade for a stock valve body?
I have looked a crossed our threads but can’t seem to find anything that points directly to this valve body or how it is constructed/set up so any links to threads would be greatly appreciated as well.