Floor Pans for 66 Dart?

[Deleted member 38666]

Just Joined, Old Dart 66 is what I'll go by. Just started restoring the 66 GT. Does anyone
know if floor pans from 62 through 65 will fit the 66? I see them in ads, but from 62-65 or
63-65. Would like to know before I order. They say not, but other research says they
will. Thanks, Old Dart 66.

 

[JBurch]

http://www.autobodyspecialt.com/cgi-bin/commerce.cgi?search=action&category=B044

This should do it for you

 

[66Dvert]

Just Joined, Old Dart 66 is what I'll go by. Just started restoring the 66 GT. Does anyone
know if floor pans from 62 through 65 will fit the 66? I see them in ads, but from 62-65 or
63-65. Would like to know before I order. They say not, but other research says they
will. Thanks, Old Dart 66.

as long as your center hump is good (or most of it anyway) yes they will.
Autobody specialties has the best ones that I have used. But you can't beat a good original that is rust free and they are on here sometimes. 2 door convertibles and 4 door were all the same for the 66 and 65's can fit too. console shift holes are different if you get a complete used setup, so mark and template yours if you have them. save the brackets.
take plenty of pictures.
I used a (got it cheap)73 front floor pan with some "minor" cutting in the seat mounting area since I am going to 97 Sebring front and rear seats for my convertible. it was weird that the 73 floor pans spot welds were almost dead on to the 66's welds. seat belt and seat mounting locations were different but I had to cut out that area anyway.

 

[Mopar Tim]

Hello old Dart66. I am in the finel stages of a 1966 Dart GT restomod. Thank God it is almost done! I have some real nice NOS and rechromed Tail light lenses and chrome bezels. Not a complete set and not the outside chrome parts. I think 3 lenses and belel. If you need let me know. Good luck with your restoration. Tim

 

[Deleted member 38666]

Hello old Dart66. I am in the finel stages of a 1966 Dart GT restomod. Thank God it is almost done! I have some real nice NOS and rechromed Tail light lenses and chrome bezels. Not a complete set and not the outside chrome parts. I think 3 lenses and belel. If you need let me know. Good luck with your restoration. Tim

Tried to send this earlier--Said it was unsent, so will try again--apologies if duplicated.
Thanks Mopar Tim--Just getting started and haven't really looked at Tail Lights closely.
Will stay in touch if needed.

Thanks, Old Dart 66

 

[cosgig]

Might wanna think about Mopar Tim's offer! Real nice stuff for early A cars are hard to go find! When I see something nice for my cars, I snap it up right away!! Just sayin!! Geof

 

[BillGrissom]

A 66 floor should be the same (or real close) to a 63-65. If I did one again, I would lap weld instead of butt-weld. It was tricky to trim to match and I got many burn-thrus.

While talking parts, I have one 66 tailight with nice chrome and good lenses. I have been too lazy to put on ebay. I bought when a newbie and didn't know it differed from my 65. PM if interested and I'll get PN and check my notes which one it is.