Kikowillers
Well-Known Member
Hi guys,
Summer is finally over here in Australia so it's time to start working on the Dart again.
I'm in the process of installing a Summit Racing Electronic Mopar Distributor (SUM-850003) and a MSD Blaster 2 Ignition Coil (8203), but I ran into a few problems. I'm no electrician so it's all very puzzling to me.
My current setup is the original points distributor with a very old looking Lucas BA7 coil, no ballast resistor anywhere. This brings me to my first question:
The RUN wire in the + terminal on the Lucas coil read 12V on the multimeter. I then measured the coil's resistance and it read 1.5ohms... so my poor understanding of electrics is telling me this coil should have burned a long time ago (shouldn't 1.5ohm coils run at 6-9V?)... Can anybody explain how this thing still works?
Now for the new setup. This is what I have to install:
These are the instructions that came with the ignition/distributor kit:
The main question is:
I know I will have to install a ballast resistor, but I can't figure out which. As you can see from the picture above, both the ignition/distributor kit and the MSD coil came with a ballast resistor each. They are 0.8ohms in the Blaster 2 kit, and 1.25ohms in the ignition/distributor kit.
So starting from the fact that I currently have 12V on the RUN wire, can somebody please explain what this installation should look like?
Any help would be greatly appreciated.
Cheers!
Summer is finally over here in Australia so it's time to start working on the Dart again.
I'm in the process of installing a Summit Racing Electronic Mopar Distributor (SUM-850003) and a MSD Blaster 2 Ignition Coil (8203), but I ran into a few problems. I'm no electrician so it's all very puzzling to me.
My current setup is the original points distributor with a very old looking Lucas BA7 coil, no ballast resistor anywhere. This brings me to my first question:
The RUN wire in the + terminal on the Lucas coil read 12V on the multimeter. I then measured the coil's resistance and it read 1.5ohms... so my poor understanding of electrics is telling me this coil should have burned a long time ago (shouldn't 1.5ohm coils run at 6-9V?)... Can anybody explain how this thing still works?
Now for the new setup. This is what I have to install:
These are the instructions that came with the ignition/distributor kit:
The main question is:
I know I will have to install a ballast resistor, but I can't figure out which. As you can see from the picture above, both the ignition/distributor kit and the MSD coil came with a ballast resistor each. They are 0.8ohms in the Blaster 2 kit, and 1.25ohms in the ignition/distributor kit.
So starting from the fact that I currently have 12V on the RUN wire, can somebody please explain what this installation should look like?
Any help would be greatly appreciated.
Cheers!