Tacfire11
Strike Hard, Strike Deep
I'm trying to weld my Axle Tubes, and yes I'm trying to pinch pennies where I can to help save for that "GAS" that the Dart will eventually be sucking down. Is there a way to get the tubes aligned for welding without spending a small fortune on a Jig?
One idea I had was to a length of pipe, or perhaps tacking on angle iron onto the individual tube sections, to hold them in alignment, and then welding up the seam. I could then cut the tacks, and finish the weld. Also, would leaving the Angle iron on the top of the top add to the stability (in case my welds suck ....)
Thanks to everyone for sharing your awesome Mopar knowledge here on FOAB :read2:.
One idea I had was to a length of pipe, or perhaps tacking on angle iron onto the individual tube sections, to hold them in alignment, and then welding up the seam. I could then cut the tacks, and finish the weld. Also, would leaving the Angle iron on the top of the top add to the stability (in case my welds suck ....)
Thanks to everyone for sharing your awesome Mopar knowledge here on FOAB :read2:.