Ritter 59 degree iron block

[Matts440]

Mine is all done for the most part besides waiting for the pistons to do a final hone on the block. Need to email the shop and see if it's done and will post pictures but will look the same as above pictures. Mine had taken a while due to other issues like the rear cap and waiting for the lifter bushings to come in.

 

[Hemirunner]

hemi runner..... can you elaborate on the Hydraulic roller build and streetable ... on pump gas...
- rocker setup and price?
- camshaft
- headers
- what vehicle did it go in
- carb size
- street manners .

THANKs

Rocker setup was a crower bedplate individual shaft rocker setup. I don’t remember cost, but around 2k.
Cam was a comp custom hydraulic roller with morel high rpm lifters. Another 2k
I don’t have the specs handy but 260ish at .050 and under .700 lift.
It went into an A-body with a 4spd behind it. Soon to be a 5spd. Extremely nice car. Headers were TTI. They’re very tight but do fit well.
It has a quick fuel 850 with a choke on it. All of these were compromises we made for streetability. Owner loves it. Big and rumpity yet very drivable. I wanted to see it crack 700hp but power wasn’t really the main goal.