No idea why a copy paste job.
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
strange
It's a God Damn conspiracy!!!No see...
Unconventional
Well-Known Member
Figured it out. Same problem as before. Something he drug over fro C-bodies. Not a member there, so it doesn't open. If I 'open in new window' I get the error page.It's a God Damn conspiracy!!!
Last edited:
I can open them from that reply box
OK, now I see both in that post...
Unconventional
Well-Known Member
From the time I quoted it to the time I posted the reply, the images went from one above the other to side by side.
Russians are hacking my stuff again I guess!
Opinions? Im flabbergasted!
This guy proclaims himself as a fabricator...
cut the perch off to use it on the ford 8.8 rear end hes putting in.
This guy proclaims himself as a fabricator...
Haven’t stopped in here in quite a few months even with a week at home I don’t have time to read back to anything. Hope everyone is doing well. I at least got my old car that’s going to parts striped down. The more I look at it, the more little pieces I want to cut off as a just in case. Upper and lower read support is still good. Maybe if I have one in the shed I won’t need it
Is it April 1st?
There's been some intristing posts n threads the past few days.
That's one of 'em.
That have the rear exhaust hangers still on it?
Just checked. Its May 11.
He dropped it off, as to him its scrap. i can use parts on my 7.25 i have sitting here. Brakes and wheel cyls are good. Will see if gears are any better.
i offered to help, but think after seeing this i would rather not get too involved.
The cuts are nice and straight.
Give him credit for that.
That power steering assembly is good also for a slant?
R4Sedan
Larry
My painter called me yesterday. Told me to stop by today. My car is pretty much done.
-
