ev2
old guy
pic are 1" relocated springs tti full ext need info or pic on 71 340 4speed duster 3"leaf spring relocation show car
vote which is the best for fit tti or dougs duster att pic
- Thread starter ev2
- Start date
-
Burntorange70
Well-Known Member
They both fit about the same from what I here. I got a set of TTI's I still need to put on. I would have got Dougs if I had known about them at the time and saved some money.
mullinax95
Well-Known Member
By looking and the pics you must have the thin motor mount isolators. I switched to thick ones and it gave me more room for the headers on each side of the engine.
I've only had 1 set of TTI's. The installation was pretty straight forward. I installed them in a 74 Duster 360, 4-Speed, Powersteering car. I did install Schumaker engine mounts.
Based on the information I found on this great typically there is an issue with the zbar making contact with the header. When I spoke to Sam at TTI about this they were aware of the issue. So he made a small block Z-bar to correct the issue. I bought one and it it works perfectly.
Good luck in your decision.
Based on the information I found on this great typically there is an issue with the zbar making contact with the header. When I spoke to Sam at TTI about this they were aware of the issue. So he made a small block Z-bar to correct the issue. I bought one and it it works perfectly.
Good luck in your decision.
So where are the pics of Dougs?
Dougs fit basically the same and cost less money. Easy decision for me.
Dougs
Dougs fit basically the same and cost less money. Easy decision for me.
Dougs
-
Similar threads
