Recent content by klunick

In the process of completely rebuilding my 67 Barracuda and decided the old gas pedal looked pretty worn. So, I purchased a new pedal and it came with all the hardware to install it. The hardware includes a metal pin, c clip, two plastic inserts that the pin goes through, and the spring. Well...

Try Auto Rust Technicians out of Cramden Rhode Island. That is where I got mine from.

None that I am aware of. My 67 Barracuda had the Rallye dash and I believe one gauge was 4 1/2", one was 4", and center one was of course smaller. What did I do? I bought Autometer gauges that are 3 1/2" and then took some 22gauge sheetmetal and cut an appropriate sized circle out. Cut the...

Perhaps remove the splash shields behind the tires???

Initially I thought this looked like a good way to go but then they went out of business. Fortunately, BEA and PG Classics started repopping them and with a little bit of effort, one can make the newer aftermarket gauges fit just fine. For race only, I could see some demand. Of course, for...

Last time I saw an OEM quarter on ebay was about 2 years ago and it went for over $2000. Putting the skins on my 67 right now. Not perfect but it sure beats the patchwork someone pulled on the car years ago when nothing was available.

Check with Tom at RT Specialties. He is sometimes hard to get ahold of but he is the master of these sorts of things.

RestoRick also carries them: http://www.restorick.com/products.asp?cat=1&pg=2 Kirk

Jim, you are truly funny, and right!! My buddy and I agree that Chrysler must have gone out and hired high school kids to do the K-frames for a summer job.

Well, I rebuilt mine this weekend. Took the unit apart and cleaned it with no problem. Went to the local ACE hardware store, bought some 10x32x1 1/4 fine thread screws, some washers, bolts with nylon lockers and a couple of nylon washers. Worked out great and will never have to worry about...

Nope, closest we can do right now is buy one for a Dart and work it. I was told the dart and cuda were very close. Anyhow, I bought the ones for the dart but have not put them on yet. I have looked them over and compared them to what is one the cuda. My best guess is, they are the correct...

Got mine off ebay a couple of years ago. These things seem to go in waves. Sometimes you will see none listed and the next month there may be 3 listed. The fronts are the same for a-bodies so those are easy to find.

I also believe They are available from R/T Specialties.

I'm looking for them too!! Don't have a picture. The cables have a loop on the end that hooks onto these plastic pieces. The plastic pieces fit into slots cut in the various plates that move when you move the controls. They are only about 1/2" high.

Cudapaz. For a long time I was thinking of getting the RMD panel. At least until they went out of business. Then I got an idea. I called Mike at BEA up and ordered a new repop dash from him. I decided to use this dash, ordered up Autometer Artic White gauges and built my own dash. In the...