Search results for query: *

Howdy all. Looking for a seal kit to re-seal my 727. The front seal started leaking so i figured i might as well do all the seals. Can anybody recommend me a kit? Thanks

Ok cool. I dont drive them in the winter so worries there

Howdy. I have a chance to buy a bucket of this at a super price. Ok to use in my mopar sure grips? Thanks

The trans is a 1993

Howdy. Looking for a quality rebuild kit for my 42rh. I already have a transgo shift kit. Trans is going in a 76 dart swinger with a 300 horsepower 360. Thanks

Getting ready to order axle bearings from dr. Diff. Are the timkins worth the extra $40? Thanks

my neighbor changed a 70 swinger from a /6 to a 318 and used the same driveshaft

howdy all. thinking of buying an aluminum pan for my 727. could you guys recommend one for me.

i paid $50 for my O500 as a core

anybody?

I'm putting a O500 trans behind my 78 360. the trans is out of a 93 dakota. what flex plate do I need? It will have a lock up convertor also if that matters thanks

Just bought a 489 case cone type sure grip. How can I test this and make sure the sure grip is good?

I need to set the pinion bearing preload. What do I torque the nut to initially to measure the drag with an inch pound wrench? I thought I read 240lbs somewhere. Is this right? Used bearings 742 case. Thanks

not an a body but drove a friends 57 chrysler 300c 392 hemi to a show last week. I noticed that when it shifted into drive too early. shifted fine, but too early. what could cause this? thanks

Yes sir

Putting an o500 Trans in my dart swinger. Any tips and advice on what mods I should make to the Trans when rebuilding it? It's out of a 1993 Dakota. It will be behind a 300 horse 360. Thanks

I have the trans plate. thats my question, what mount do I buy?

what are you guys using for a trans mount for a 0500/0518 swap in a 76 Dart?

I have a 64 valiant two door sedan. i'm restoring it and want to make a cruiser/mild stree car. It will have a 400hp 360 with a cast iron case OD 833. i also have a 8 & 3/4 rear for it. what would be good gear set to run? thanks for any input

how strong/reliable are re-splined C-body axles? I want to switch my 69 dart to big bolt pattern.

I've seen some articles on swapping a O518 trans for a 727. has anybody used the O500 instead of the O518? If the O500 is physically smaller, maybe it wouldn't require floor pan and crossmember mods. this would be for a small block A-body.

either a 904 or 727 will work.