I have a set of older AMR S200 Daisy Mags. What is the correct mag lug shank length I should buy... .5 or .55? I know that they should not bottom out on the hub. I do not know how thick the lug washers usually are either.
Shank Mag Lug Nut Length?
- Thread starter banzaibullitt
- Start date
-
Measure them, is the only way I know. I cannot imagine that a bit shorter will hurt, as long as they pilot. Make darn sure that they the wheels DO WANT shank type and not coned/ countersunk
The wheels measure out at .5 inch thick at the lug hole, and they require the shank style lugs. Does anyone know how thick the lug washers usually are?
33IMP
Well-Known Member
I have tho old one piece daisies too. Washers are1/8". Buy the 1/2" shank, and double check that they don't stick out past the hub (they shouldnt).
^^^^ Thanks!
MoparLeo
NRA BENEFACTOR LEVEL LIFE MEMBER
33IMP
Well-Known Member
Those won't work if he still has 7/16 studs.
I would measure the wheels and buy the correct lug not needed. (diameter, length, and thread size) You may have a hard time finding the right ones for those old wheels.
-
Similar threads
- Locked
