One change I'll do when I go fishing again is a head lamp vice flash light. I can position the nozzle to where I can get at one end, will try to do that and either run a wire into it or ???
Jack the mower up towards the side of the fill, May helpI hooked a fuel line while reaching for the nozzle filler but didn't hurt anything, went ahead and mowed the whole lawn. Will try fishing with different fuel levels in the tanks, have better things to do but it's bugging me for now...
Have you goggled it?? You can't be the first it's happened to.One change I'll do when I go fishing again is a head lamp vice flash light. I can position the nozzle to where I can get at one end, will try to do that and either run a wire into it or ???
Not to many choices left on how to get it out unfortunately.
.A cheap siphon pump and drain the gas??One change I'll do when I go fishing again is a head lamp vice flash light. I can position the nozzle to where I can get at one end, will try to do that and either run a wire into it or ???
You've done a great job Ray. Work just as hard now and keep it off.Morning. Finished shopping. Half asleep getting dressed forgot my damn belt.
Almost dropped trough a few times.
Came home belts tight pants no.
Pulled out a pair of 34" ones haven't fit in those in about 10 years, perfect.
Surprised I still had any. Then again I have about 300 tee shirts 80% of which now fit like a tent.
Fast breakfast this morning.
Micro wave bacon, and Jimmy Dean no bread sausage egg and cheese.
View attachment 1715767217


Empty tank, alien tape on a stick, wire whatever. Ask @halifaxhops .One change I'll do when I go fishing again is a head lamp vice flash light. I can position the nozzle to where I can get at one end, will try to do that and either run a wire into it or ???
I once loaded the back of my 68 Barracuda fastback with beer cans at an off campus party once in Michigan and made $52 for going to that party and collecting the cans and bottles....
A full pickup bed full would be $$$....
Plastic or metal????
So i went and fished the hose out of my fuel tote that burned off. Im still amazed it didnt explode. A 3 foot long piece of mechanics wire with a loop on the end. Managed to get it near opening and grabbed it with needle nose pliers.
Empty tank, alien tape on a stick, wire whatever. Ask @halifaxhops .
Call this guy...That could work, not sure where nozzle will end up at but might be able to bring it up to "shelf" with wire and position it so nozzle comes up and out from end. Otherwise it hits the hole sideways....cue Carl!!!
"Mr Kuda, you're charged with 520 counts of open container. How do you plead?"
"Your Honor, I plead environmentally conscious."
"Bailiff. Whack his pee pee!"

Neck of tank is too long for the needle nose pliers I have, also the long hemostats.
Neck of tank is too long for the needle nose pliers I have, also the long hemostats. If I drain the tank the nozzle will go to the bottom of the tank, too far to reach. There's a "shelf" that is about 5 inches down, that's my best starting spot.
Good Morning gents
