7duster4
Well-Known Member
I recently had new leaf springs installed on my Duster, and the guy who put them on said after a short time, the rear will go down about 1 inch for a nice stance. About a week or two after that I noticed the drivers side of the car was sitting about 1 inch lower than the other side. I was very noticable then I drove it a little and the drivers side went up just a tad. But that was 2 weeks ago and the drivers side is still sitting about half an inch or so lower than the other side. Also put new shocks on and no change. I was told that there is an adjusting bolt for the torsion bar that needs to be turned. Problem is I can't turn it. It's rock solid, and needs to be tighten maybe one turn from what I was told. Does the bolt need to be soaked in something in order to get it loose?
Any help would be appreciated. Thanks
Any help would be appreciated. Thanks