Search results for query: *

Still no Bullitt...

Edelbrock carbs will generously flood with fuel under as little as 7.1 pounds of pressure. This would cause the car to idle poorly, especially under load and will smooth out and behave once RPMs are higher and the bowls are not allowed a chance to fill up... Simple test: start the vehicle...

My older dog Bailey use to open the fridge and eat all the sour cream. There could be a tull on tri tip in there but nope... SOUR CREAM Also he blinks in about nine of ten pictures...

Favorite guitarists are like favorite cars, ya cant just have one. But if you want to talk about live performances how about the best live solo sequence of the year circa 1990 (not a bad year if i do say so myself) :) http://www.youtube.com/watch?v=VnqpOFcBiMM

Hey folks, i am trying to my 73 swinger. It is originally a 318, a/c car but has since been altered with a slant and they were nice enough to rip the air out. Shes a little rough. It is rattle can with grey primer, the interior needs work (carpet, door panels, dash cover) The engine runs and...

bump. did i mention it is fretless? Ill take what i can get for it. just need some extra cash asap. Thanks guys

I have had this in storage for 2 years and have finally decided i have no more use for it. It is transparent red with active electronics (9 volt, you can use 18v with a piggy back box). Ive played many gigs with it it sounds true, feels great, and plays great. It has scuffs and scratches from...

choke stuck?

between the comments about re-tightening your intake, the low vac, and the white smoke, I would say you should pull that bugger and put some new gaskets in properly before something major gets damaged. also, have you checked your oil for water?

Quite the handsome pup! Here is one of my Golden (i know, hes blonde, get over it, lol) when he was a puppy (no joke... 6 months old...)

check for head gasket. aside from an obstruction, its the last viable cause for heat up

Welcome to FABO Jennie. Looks like you are in good company for sure. btw, Where about in NorCal? I am in Antelope/Roseville myself.

It CAN. But really shouldnt in most cases. For some reason if i hold the fender of my 73 Swinger and touch the primary + post, I get quite the nice zap. Its more of a pulsing, akin to the chiropractic "Tens" units. I enjoy it a little bit. lol btw, Faulty or old or badly seat plug wires can...

defintaly with the nehi! How about a moxie anyone?

for testing purposes you can run the ign + to coil + through the spare you have while leaving the ecu plugged into the old one. a little more simple to just rig a jumper for now to see if thats your issue and if it is, just buy a new resistor

there should be one on the drivers side firewall. It may be good to use, but i would grab a new one as precaution. The link i posted will show how to wire it to the ecu. with the blaster coil, you DO need the resistor, as the blasters are not internally resisted.

i named mine after my ex girlfriend, the b!tch!

It falls off a bit. I noticed the difference from the stock unit and the chrome unit. it just depends on how many 4000k+ passes you plan on throwing at it.

they work on both. the 5 pin uses a 4 pin ballast resistor while the 4 pin ecu works with the two pin resistor http://www.mymopar.com/downloads/elecignconv.pdf < that will tell ya all you need to know on the install.

Now that I am working again, I'm starting to work on my sedan alot more and have actually been thinking about paint and what not. I would like your opinions. goal with the car is somewhere between these two photos. pic 1 is car in current condition and 2 is a sample car

uhhh.... women? lol. but seriously. Aside from wrenching I am into music. Ive been a musician for over 10 years and was on tour all through high school. Slappin da bass!

full size starter + heddman hedders = PITA!

73SWING is the plate number on my... you guessed it! 1973 Swinger!

9. may be an Ignition buzzer. (all time most annoying part of a dart) i just keep mine unhooked

That is fantastic Ramcharger, and I sure do know the feeling. After 4.5 months out of work I start my new job tomorrow morning! Have one for me bud, and heres to you!

I dont know anything about the pistons, deck, or heads as the po was the one that built it. All i can find in his notes/reciepts is that it is 9:1

shes gettin rebuilt at the same time btw.

Thank you for the opinion, worth looking into for sure!

I think I am going to stick to new on this one, but thank you.

Well I finally got a new job and I start saturday. I am so excited about paying a little more attention to my Darts, rather than just driving the crap out of them and praying they stay running. The 318 in my 72 4 door has a bad cam in it (3 lobes almost gone) and im in the market for a cam...