Search results for query: *

I'm starting to get my 273 back together , anybody know which side of motor timing tab goes ?? 1968 273 I think it goes on the passenger side

Has anybody every installed a v8 sb with headers on it in a 68 Val ? From the top ?

Ok , cpl questions, 1 can I change to a straight oil filter ? ( dnt like the 90 degree one ) 273 engine 2 what about an oil filter relocation kit

Anybody uses oil catch can ?? If so how did you install it

I just went to install my Wiand 8004 intake manifold it lines up To heads only problem the front and rear cork gasket raise it up to high and away from the heads what do I do. ( any thoughts on gasket type metal or fiber ??? )

My question is do you really need to have a by pass hose from the water pump to the intake ?

Just rebuild 273 engine installed Big cam hyd / adj drive train was looking into putting a intake valley pan . Are they worth the money ? Any advantages other than keeping the intake clean and cooler ?? Thank you in advance Ray

Ok here it goes the gasket kit I bought for my 273 engine came with a lot of gaskets !!! My oil pan collar has slots in it both ends ok , now the gasket kit has two different type of robber gaskets for the pan inc the cork for the sides ( length ) of pan , Now when I took the pan off it had both...

Is there a certain way the pistons face, and how about the rod bearings is their a certain way the go in too 273 std bore engine

Ok I have a LA 273 1968 engine 2 brl I'm rebuilding std bore , std pistons , std rods etc i had crank polished ( std size also ) rods and pistons cleaned ok cam is 484 / 484 lift have adj rockers want to have heads milled to increase compression to 10.1 how much does it need to have taken off ...

Looking at the heads on my 273 not sure what the numbers indicate as to what the heads are ??? 2843675-13. 03228. AAWJ

I have a LA 273 engine I'm playing with changing cam , lifters, valve train , I'm changing to a double roller timing chain . My question is will I still need to use the chain tensioner ?

I'm changing to a sml block all ready changed k- frame found a HP LA-273 4brl engine, my ride is a 68 ply val 2dr post . engine has no motor mounts or plates connected to it, I have some from a old 318 engine plates but can't remember :banghead: if they bolt on the inside of the ears or the...

my engine pops at idle but runs strong otherwise

I found these heads on MOPARTS they are 340 Z cast # 918 what can anyone tell me about them ???? will they work on a 1968 318cu engine thanks Z_daddy