osxdos
72' Duster / 360
Yep here
Yep but, if it wasent for brad I'd prolly still be out there, but I got to tear it down again, but its home nowDid you get it repaired?
Haha look bout to find out if jb weld is worth a grain of saltYep but, if it wasent for brad I'd prolly still be out there, but I got to tear it down again, but its home now
It worked !!!!? I got to start it three times I left the ziptie on must a came off, hmm might be push button time until I figure out what kinda switch IMA get. That one IS OEM ...My fingers are crossed for ya! Good luck.
Easy yes. But right now I'm starting it *via brown Mopar ignition bypass wire and starter relay, hmm hmm hmm, this should be fun, 5 wires on switch, my battery is mounted in trunk time to make new threadOwn is easy to find. Got mine on eBay.
I mean yea it I wasent poor I guess.Cant you just get another ignition switch for it ?
Not sure what you mean by that.I mean yea it I wasent poor I guess.
Yea you got a point. I really don't want a push button anywayNot sure what you mean by that.
But by the time you hack into the wiring and get a push button starter switch and then another switch to turn the coil power off or on you might as well spend the 38 bucks and do it right ?
Not sure what you mean by that.
But by the time you hack into the wiring and get a push button starter switch and then another switch to turn the coil power off or on you might as well spend the 38 bucks and do it right ?
Besides that you have allready busted your *** getting the column apart to get to the switch.IW is right. You will have more than $38 tied up and will have a hacked up wiring to top it off.
Yea I'll get a switch. Used switch ?Besides that you have allready busted your *** getting the column apart to get to the switch.
when the Tumblers went out I got the key Inn and then position them just right so when I take the key out I can slide it back in easy and it works that way with my girlfriend she took the key out I forgot to tell her and she tried forcing it and she messed it tumblers up and needless to say I was stuck in the shopping center so I had to tell her to call him down I couldn't get the key back in but before that I was so pissed that I couldn't get the key in that I took a flat head and started hammering it through the ignition that's probably how it broke but then I realized that I was thinking irrationally I stopped and this is where I'm at it could have been a lot worse I was pissedhow did you break the ign switch like that? i see the column has a part broken off also.. hopefully it doesn't allow the tumbler to move back and forth..
I got a new shiney key cylinder in it alreadySo now you need the ignition switch, and the key cylinder that you pounded the screwdriver though.