Pulling it out

[Wolfgange]

Done chev V8s chev 235s and 250s Did a 66 318. But where do you put the chains on a slant???? Sure don't want to bust the manifolds, they look pretty vulnerable. Any ideas or pictures welcomed. Looking for the right SLANT to this question. Thank you gentlemen, and those that aren't also

 

[Charrlie_S]

There are two bolt holes on the cyl head between the valve cover and the manifolds. Use these holes.

Best way to lift a slant 6 engine block ?

Hello all , I have my engine on a stand right now and will be installing it shortly . What is the easiest and safest way to lift it ? I had a chain under the block at the front and bolts in the bell housing for the back . It came out, but it was quite awkward and tilted a lot . I have not...

www.forabodiesonly.com

 

[Badvert65]

Of those two holes, the front hole is a single lift point to balance the engine only. The rear hole is a single lift point to balance the engine/trans together.

 

[Wolfgange]

Charrlie_S and OL Badvert65 Fellas don't know if your Gentlemen or those that aren't. But I thank you both. Give yourselves a cookie. THANKS

 

[Charrlie_S]

Give yourselves a cookie. THANKS

I just had 4. I'm a glutton

 

[TT5.9mag]

Front passenger side and rear driver side of the cylinder head.