beet juice? I stopped drinking that stuff a couple years back. You should have seen the look on the drug testers face at my Guard unit when i turned in a cup of purple tinted pee...Drinking beet juice will do that to ya!
Stop in for a cup of coffee
- Thread starter toolmanmike
- Start date
-
throttle cable intact.
Beet juice flashbacks then?
j par
Well-Known Member
Quitter!
Mattax
Just the facts, ma'am
makes a good ground
when connected to a hot
Look for a rub on it near where the wires are, it will not be insulated there if that was the cause. Have heard of five or six of them starting that way.
haha its like reading ancient Egyptian when i try to understand electrical diagrams lol
Ok, finally all caught up from yesterday...
Now off to cook some lunch and help the kid fix his burnt out bulb in his turn signal...
Now off to cook some lunch and help the kid fix his burnt out bulb in his turn signal...
Sure does!makes a good ground
I shall check. thanks!
Is it bad that the only part of either project I actually dread is electrical wiring? Body work, panel replacement, engine building etc is all easy for me to understand.
j par
Well-Known Member
I thought it was pretty simple? Wire Starts Here follow blue wire around to there?
You're still going to have to learn how to read a wiring diagram to get the right connections hooked up....
Actually that charger I did the distrib on was just worn through there also and that is a 440 6 pack car, 100% stock.
I always wondered what started the fire.
You're still going to have to learn how to read a wiring diagram to get the right connections hooked up....
so make sure the wires are far away
j par
Well-Known Member
I found it very satisfying to pull my dashboard out and have it on a bench and being able to just stretch all the wires out and see where they go. Instead of a squiggly diagram it turns into easy straight lines.
The pop it was the throttle cable wore through a wire at the firewall then the factory tape was a freaking fuse. I used racers fire resistant tape when I re did it. That was freaking scary.
im thinking of using the plotter on base to make a wall map sized print out of the factory wiring diagram.
I sleeved mine with a rubber hose also in case it shifts back.
Unconventional
Well-Known Member
Here come those Santa Ana Winds again.
https://r.search.aol.com/_ylt=Awr9D..._1_ySlaY/RK=0/RS=1v4gJZVXTJ4rFs7JMZutqKd0ZXM-
https://r.search.aol.com/_ylt=Awr9D..._1_ySlaY/RK=0/RS=1v4gJZVXTJ4rFs7JMZutqKd0ZXM-
Unconventional
Well-Known Member
You can see one here that is close.
Actually kind of miss them from when I lived in Mountain View.
-
Similar threads
