flyboy01
Its almost done!
Lask week I took my rods down to the engine shop to get the pistons and pins pressed on and the big ends resized and arp bolts installed, that was Monday.
I got bad news from the machine shop today, all but one of my rods are bad. The small ends where the pin presses in is too large for an interference fit. Luckily I have that 400 engine sitting in the garage, I am going to pull the pistons and rods and take them down to him today.
I got bad news from the machine shop today, all but one of my rods are bad. The small ends where the pin presses in is too large for an interference fit. Luckily I have that 400 engine sitting in the garage, I am going to pull the pistons and rods and take them down to him today.