Hi,
I'm planning to do a hei swap.
Got the kit from TrailBeast and thank you for that.
Only problem is that I'm using an toyota alternator (same as delco swap)
Diagram here: [ame]http://arengineering.com/wordpress/wp-content/uploads/ARE-AR022-proof.pdf[/ame]
Now I have tried to figure out how to connect the ignition wire coming from the alternator.
All the diagrams show only the S should be connected to the new coli + and that's it.
Like this: http://i163.photobucket.com/albums/t304/bherder/GMHEISchematic.jpg
How to rewire the ignition part?
Currently my IG goes from Alternator to resistor and from there to ECU box (like shown here http://i1207.photobucket.com/albums/bb476/waynep712/Mopar_Electronic_Ignition_diagram.jpg~original), but if I remove them then where it should go?
Thank you
Kristjan.
I'm planning to do a hei swap.
Got the kit from TrailBeast and thank you for that.
Only problem is that I'm using an toyota alternator (same as delco swap)
Diagram here: [ame]http://arengineering.com/wordpress/wp-content/uploads/ARE-AR022-proof.pdf[/ame]
Now I have tried to figure out how to connect the ignition wire coming from the alternator.
All the diagrams show only the S should be connected to the new coli + and that's it.
Like this: http://i163.photobucket.com/albums/t304/bherder/GMHEISchematic.jpg
How to rewire the ignition part?
Currently my IG goes from Alternator to resistor and from there to ECU box (like shown here http://i1207.photobucket.com/albums/bb476/waynep712/Mopar_Electronic_Ignition_diagram.jpg~original), but if I remove them then where it should go?
Thank you
Kristjan.