Search results for query: *

My 82 Dodge PU was idling in the garage. I heard a small pop/poof and engine died. Looked under the hood, no smoke, no smell, nothing. Go to start it and it starts right up, but as soon as release the key it dies. Right away I'm thinking Ballast Resistor ( 2-pin) I replace it with new. Same...

Generic set of trim rings for 14" Rallye Wheel. No scuff, scratches. or dings. $25.00 plus shipping. Located in Ohio

Nice used 35T Orange Speedo gear for 4 speed. $20.00 plus shipping. Located in Ohio.

Used original master cylinder taken off my 70 Duster that had Disc on the Front and Drums on the rear. Worked fine when I removed it, but would reccomend rebuilding it. Rebuild kit comes with it. Best reasonable offer plus shipping. Located in Ohio

Nice used 32T Black Speedo gear for 4 speed A-833 Tranny. $10.00 + Shipping Located in Ohio

2 Aluminum Wheels spacers for the SBP 14" hub. $25.00 OBO + shipping. Located in Ohio

Two 14 x 7 SBP Rallye Wheels from my 70 Duster. Excellent condition with the correct wheel paint. No center caps or rings. $120.00 for both plus shipping from Ohio

Used set of scuff plates from my 70 Duster. Not the best shape, but not beat up too bad. Make offer! Located in Ohio

A repo Set of arm rest covers purchased for my 70 Duster but never used. Still in Box. $20.00 plus shipping. Located in Ohio

Removed these covers from my 70 Duster. On the one end of both of them they are chipped off, but the outer piece does cover them. Pretty decent shape other than that. $20.00 OBO. Located in Ohio

Black Steering wheel with cap. Excellent Condition. No cracks or splits. Removed from 70 Duster. Asking $60 or best offer plus shipping. Located in Ohio.

Selling complete 3rd Member with 2:76 gears Open rear end. In good condition. Bearings good, Teeth Good, no whining. Date on gears is 6-29-1970. $200.00 plus shipping. Located in Baltimore Ohio

On a rear end yoke that I am looking at, it has the numbers 64 (space) 072640 on one side and Armasteel on the other side. Is this considered a 7260 yoke or a 7290 yoke? It is sitting in a 2881489 case. Thanks

Necessary? Had to remove the oil pump to replace the seal. One guy suggested I just loosen the oil filter, remove the coil wire, and crank until I see oil coming out around the filter. Never heard of this, has anyone else?

When I rebuilt the 340 engine 2 years ago, it had an Accel dual point distributor w/o the vaccum advance on it and ran decent. After the rebuild I installed a brand new Mopar Electronic unit in the car.(with vacuum advance) The car had only about 100 miles on when I took it to the Nationals...

1970 DUSTER 340 4-SPEED MATCHING NUMBERS-RESTORED TO ORIGINAL STOCK CONDITION-FENDER TAG & FACTORY BUILD SHEET INCLUDED B-7 Blue with Black Bucket Seats & Interior that has had every nut and bolt removed and reassembled. The body was stripped and repainted in 2006. In 2009 and 2010...

When I purchased this car I was told there was a new Center Force Clutch & PresPlate installed. The car had some Z-Bar linkage issues but I took care of that. But what I noticed most was, when half way power shifting the car did not have a significate power bang to it. It just eased it's way...

Or does anyone know WHO owns this 70 Duster? Saw this somewhere but no mention of owner or where car is. Identical to the one my brother bought new in 1970. Would like to correspond with owner. Anyone??

I have a set of original leaf springs I took off the 340 Duster. Are these things worth anything? Can't tell you if they are bad or not as the suspension had air shocks on them when I removed them. They appear to look OK other than one of the bands broken. Can deliver to Mopar Nats if anyone...

Subject: 70 Duster, 4 piston Kelsey Hayes caliper up front, and 10" drum brakes in rear, all original, no power. Before restoration of the suspension started everything was fine. Calipers were recently rebuilt. New Master cylinder installed along with new lines & hoses. 1st problem was a...

Has anyone tried this combination of wheel and tire on the front for a 70 Duster? I know it will fit the rear, but not positive about the front. Have the tires, just haven't mounted them yet. The rims are stock type rally wheels 14 x 7. BF Goodrich 225/70 14 tires. 26.40 inches tall. The rims...

Putting 340 engine back together. Purchased new rocker shafts and stock rocker arms. You have 5 bolts and retainers per side to bolt the shaft down. 6 of the retainers are not as wide as the other 4. I am thinking that the narrow retainers go on the ends and in the center (3) and the other...

Looking to replace the gas tank on my 70 Duster 340. The tank on the car now has the 4 vent tubes and 3 of them are blocked off. One vent has an open hose but not connected to anything. There is a small vent tube in the trunk that runs along the filler neck and into the trunk pan but it too is...

When you re assemble the Z-bar with the nylon bushings and ball studs, do you only lubricate those parts or do you pump the whole shaft full of grease? Any particular grease, chassis, white lithium, Wheel Bearing, etc??

Looking to purchase tti Exhaust including tips for my 70 Duster, Does anyone have any pictures of the exhaust tips they can download?? Not crazy about having the tti engraved on them and want to see what they look like. Their website doesn't have any good pictures. Anyone have any other...

A car that did NOT originally come with them?? Did you run into any problems other than measuring 20 times and drilling once? Were you able to get the right clips/screws/other fasteners?? Any tips or suggestions OR maybe just forget it ! Looking to install on a 70 Duster and looking for...

Was looking to replace my dual point distributor with the Mopar Ignition kit. Cost is $217.00 from Jegs/Summit. They also advertise a Proform Kit which "LOOKS" the same for about $139.00. Just checking to see if anyone has used this kit and the quality of it compared to the Mopar kit. Thanks

Looking for a stock 340 ci OIL PAN for my 70 340 Duster. Must be dent free and in good shape. Would like to have one with 3 digit code 294 Thanks A340

Passing and looking for good info. Have stock 340-4bbl 4spd 391 gears Duster. Had original Carter AVS carb. After spending bucks and a lot of time, rebuilding, replacing, adjusting and tweaking I could not get it to idle and run right. I'm convinced that a 40 year old carb warps, melts, and...

70 Duster AM thumbnail radio. Has been working fine. All of a sudden goes dead. Checked Fuse OK, Checked wiring Connections, OK Any suggestions on what to try next? Any fuses inside radio??